Professional Motorized Electric Heavy-Duty Wall/Ceiling Mount Multi Backdrop/Background Support System with 3.15M cross bars.
The system consists of 3 parts: an electric motor with wired remote control, three 3.15m cross rods and a steel wall/ceiling mount to hold the rods.
The system is powered by AC power. Power cable length about 270 cm. Wired remote control is equipped with 3 buttons for each cross bar and a power switch. The cable length of the wired remote is about 210 cm.
The 3 shafts are aluminium pipe with a diameter of 47 mm. One end of the shaft (with no holes) is freely inserted into the hole in the supporting mounting plate. The opposite end of the shaft (with a hole) is inserted into the motor抯 mounting plate and secured with supplied nut and bolt. You can replace or set the background by rewinding it from the sleeve to the shaft, securing the edge of the background with tape. Or put the background together with its sleeve on the shaft, compensating for the difference in the diameters of the shaft and the sleeve with suitable elastic materials (rubber, dense foam, foam plastic, etc.). Thanks to such inserts between the shaft and the roll, the latter will not rotate on the shaft. Since the inner diameters of the rolls are not standardized, there is no other way but to use anti-slip, compensating for the difference in shaft diameters. When you want to change the backdrops, when installing the wall mounts remember to leave an additional 20mm clearance on the length of the aluminium rod to allow installation and removal of the aluminium rods.
This motorised multi backdrop system provides an automated solution, allowing you to have easy access to multiple backgrounds at any time.
